REMOVING AND INSTALLING
CLUTCH HOUSING

Remove and install transmission 23 00 020.
From 1981 Models:
Remove and install transmission 23 00 022.
Remove guard.


Siehe auch 23 00 020
Siehe auch 23 00 022
73021011 - click to zoom
 
Only for 733 i with DME:
Unscrew bolts.
Lift clutch housing.
Pull out speed (1) and reference mark (2) sensors.
Important!
Watch installed position.
Don´t mix up plugs.
Install black plug of speed sensor (1) to gear ring
and plug with gray ring (3) of reference mark
sensor (2) to flywheel.

2821004 - click to zoom
 
Installation:
Check O-rings, replacing if necessary.
Install sensor with Molykote Longterm 2.

2821005 - click to zoom
 
Unscrew bolts and take off clutch housing.

73021012 - click to zoom
 
From model '83
REMOVING AND INSTALLING CLUTCH HOUSING
Remove and install transmission 23 00 022.
Cars with DME:
Remove heat shield.
Unscrew bolts (1 and 2).
Pull out speed sensor (3) and reference mark
sensor (4).


Siehe auch 23 00 022
73021020 - click to zoom
 
IMPORTANT! - INSTALLATION:
Check installed position.
Plugs must not be mixed up.
Install speed sensor (3) in bore (D) and reference
mark sensor (4) with ring (5) in bore (B).
Engine cannot be started if plugs are mixed up.

73021021 - click to zoom
 
Installation:
Check 0-rings.
Install sensors with Molykote Longterm 2.
Important!
Face surface of DME sensors must be free of
grease and dirt.

73021022 - click to zoom
 
Unscrew clutch housing.
Use a Torx socket** to unscrew Torx bolts.
Important! - Installation:
Torx bolts must be installed with washers to
avoid an increase in breaking-loose torque.
Tightening torque*.

** Source: HWB


Siehe auch * See Specifications
2821006 - click to zoom