From model '83
REMOVING AND INSTALLING BRAKE PEDAL
Detach and attach instrument panel trim at
bottom left 51 45 180.
Unscrew lock nut (1) and release over-center
spring with nut (2).
Installation:
Insert over-center spring in arrest and adjust to
distance (A)* with clutch pedal installed.
Tightening torque*.


Siehe auch * See Specifications
73035011 - click to zoom
 
Detach piston rod on clutch pedal.
Installation:
Check bushings for wear, replacing if
necessary and installing with lubricant*.
Tightening torque*.


Siehe auch * See Specifications
73035012 - click to zoom
 
Disconnect return spring for brake pedal.
Remove piston rod lock on brake pedal and
remove shaft pin.
Installation:
Check specified distance* for brake pedal,
adjusting if necessary.
Check adjusting distance* for stop light switch
and correct, if necessary.


Siehe auch * See Specifications
73035013 - click to zoom
 
Unscrew stop nut on shaft bolt.
Pull out shaft bolt.
Remove clutch and brake pedals downward.

73035014 - click to zoom
 
Remove brake pedal from clutch pedal.
Installation:
Check bearing bushings (1) for wear and install
with lubricant*.


Siehe auch * See Specifications
73035015 - click to zoom
 
Installation:
Check distance (A)*, adjusting on piston
rod if necessary.
Check distance (B)* for stop light switch.